Manual De Utilizare Epson A Văzut 36-075 [17/21 Pagini]

Epson a văzut 36-075

Fig. 45

Fig. 46

MAINTENANCE

CHANGING THE BLADE

WARNING: USE ONLY CROSS-CUTTING SAW

BLADES. WHEN USING CARBIDE TIPPED BLADES,

DO NOT USE BLADES WITH DEEP GULLETS AS THEY

CAN DEFLECT AND CONTACT THE GUARD. USE ONLY

″″

DIAMETER SAW BLADES WHICH ARE RATED FOR

6000 RPM OR HIGHER AND HAVE 5/8

″″

DIAMETER

ARBOR HOLES.

1. DISCONNECT THE MACHINE FROM THE POWER

SOURCE.

2. Remove screw (A) Fig. 43, and rotate cover (B) to the

rear as shown in Fig. 44.

3. To remove the saw blade, insert hex wrench (C)

Fig. 45, into the hex hole located on the rear end of the

arbor shaft, to keep the shaft from turning.

4. Using wrench (D) Fig. 46, loosen arbor screw (E) by

turning it clockwise.

5. Remove arbor screw (E) Fig. 46, outside blade

flange (F) and saw blade (G) from saw arbor.

6. Assemble new saw blade MAKING CERTAIN TEETH

OF SAW BLADE ARE POINTING DOWN AT THE

FRONT and reassemble outside blade flange (F) Fig. 46,

and arbor screw (E) by turning it counterclockwise using

wrench (D) Fig. 46. At the same time use hex wrench (C)

Fig. 45, to keep the arbor from turning.

7. Replace screw and cover that was rotated to the

rear in STEP 2.

WARNING: REMOVE WRENCHES (C) FIG. 45, AND

(D) FIG. 46, BEFORE TURNING ON THE POWER.

Fig. 43

Fig. 44

manualeocean.ro

Informații

Epson a văzut 28-293

Epson a văzut D28715

Epson a văzut 36-714

Epson a văzut 28-276

Epson a văzut DW870

Epson a văzut RS830

Epson a văzut DW861W

Epson a văzut DW368

Epson a văzut DW7464

Epson a văzut DW746

Epson a văzut DW7440

manualeocean.ro

Informații